Salty Cruiser Anchor Decal

Clean gently with mild soap, water, and a soft cloth. Avoid abrasive scrubbing and directing pressure-washer spray at the edges.

Permanent adhesive vinyl is intended for a lasting application and is not reusable. To remove, gently warm the decal and peel slowly. Adhesive residue may remain; test any remover in an inconspicuous area first. Removal can affect delicate or deteriorated finishes.

Cut from ORACAL 651 permanent adhesive vinyl for indoor and outdoor use. Only the design remains after application—there is no background or clear border.

Best suited to clean, smooth, flat surfaces such as glass and properly cured painted metal. Not intended for fabric, textured surfaces, or temporary wall decoration. Transfer tape holds the design together during application.

Each decal is cut and prepared to order. Please allow 2–4 business days for production before shipment. Shipping time is additional.

Select your preferred size and vinyl color before adding to cart. Sizes are listed as width × height in inches and measure the complete vinyl design, not the backing paper.

Check the available space before ordering. Actual vinyl colors may vary slightly from your screen.

1. Clean the surface thoroughly and let it dry completely. Remove dust, grease, wax, and silicone. Use isopropyl alcohol only if compatible with the surface; avoid cleaners that leave residue.

2. Apply in a dry location, ideally at 65–75°F. Both the surface and air must be at least 46°F.

3. Rub firmly over the transfer tape, then slowly peel the backing paper away. If any vinyl stays on the backing, lay it back down and rub again.

4. Position carefully. Press the design onto the surface, then smooth firmly from the center outward with a squeegee or plastic card.

5. Slowly peel the transfer tape back flat against itself. If the vinyl lifts, press it down and try again.

Keep the applied decal at a steady temperature for the first 24 hours.